GE IS210BPPBH2BMD模块备件

GE IS210AEBIH3BEC

in the AUTO mode, the feedback
signal must be connected to analogue input 2 (AI2) and the
START command is given with digital input 1 (DI1). By default,
the setpoint is set from the control panel (operator keypad), but it
can also be given through the analogue input 1. Process PI(D)
must be commissioned and adjusted with parameters (Group
40: PROCESS PID SET 1) or using the PID control assistant
(recommended).
© Copyright 2007 ABB
ACH550-01 User's Manual
Application macros and wiring 109
1 SCR Signal cable shield (screen)
2 AI1 External reference 1: 0(2)…10 V or 0(4)…20 mA
3 AGND Analogue input circuit common
4 10V Reference voltage +10 V DC
5 AI2 Actual signal 1: 0(2)…10 V or 0(4)…20 mA 2
6 AGND Analogue input circuit common
7 AO1 Output frequency: 0(4)…20 mA
8 AO2 Output current: 0(4)…20 mA
9 AGND Analogue output circuit common
10 24V Auxiliary voltage output +24 V DC
11 GND Common for DI return signals
12 DCOM Digital input common for all
13 DI1 Start/Stop: Activation starts the drive
14 DI2 Run enable: Deactivation stops the drive 1
15 DI3 Not used
16 DI4 Interlock: Deactivation stops the drive
17 DI5 Interlock: Deactivation stops the motor
18 DI6 Not used
19 RO1C Relay output 1 (par. 1401)
Default operation
Aux. motor switched on => 19 connected to 21
20 RO1A
21 RO1B
22 RO2C Relay output 2 (par. 1402)
Default operation
Running => 22 connected to 24
23 RO2A
24 RO2B
25 RO3C Relay output 3 (par. 1403)
Default operation
Fault (-1) => 25 connected to 27
26 RO3A
27 RO3B
1 Disable/enable with parameter 1601 2 The sensor for AI2 is powered externally (not shown in the figure). See the manufacturer’s
instructions. To use sensors supplied by the drive auxiliary voltage output, see page 124.
Note: The drive starts only if possible protection functions (Run enable or Start enable 1 and
2) are activated from I/O or disabled with parameters.
1…10 kohm
Pump alternation
ACH550-01 User's Manual
110 Application macros and wiring
8. Internal timer
This application macro is for applications where the motor is
started and stopped with a built-in timer. This macro has also a
boost function which operates the motor after digital input 3
(DI3) has been momentarily activated. An example of the timer
usage is shown below. For further information see chapter Realtime clock and timed functions.
When using a direct speed reference in the AUTO mode, the
speed reference must be connected to analogue input 1 (AI1)
and the START command is given with digital input 1 (DI1). In
the HAND/OFF mode, the speed reference and START
command are given through the control panel (operator keypad).
If process PI(D) is used, the feedback signal must be connected
to analogue input 2 (AI2). By default, the setpoint is set from the
control panel, but it can also be changed to analogue input 1.
Process PI(D) must be commissioned and adjusted with
parameters (Group 40: PROCESS PID SET 1) or using the PID
control assistant (recomm