Woodward 8924-574模块现货

Woodward 8924-574

局域网端口
用于直接连接到设备或网络的以太网连接器
受保护（本地设备或网络）。
USB连接器
用于连接到计算机的USB接口。
用于电源（默认设置）。
FL MGUARD SMART2（不是FL MGUARD SMART）可以是：
配置为通过USB连接器提供串行控制台（请参阅
第5.3.1.5节）。
广域网港口
用于连接到外部网络（如广域网、互联网）的插座。
（通过此建立与远程设备或网络的连接
网络）
使用UTP电缆（CAT5）。
之前：
之后：
（局域网也可以是
在左边）
如果您的计算机已连接到网络，请插入FL MGUARD SMART2
在计算机的网络接口（即其网卡）和网络之间。
不需要安装驱动程序。
出于安全原因，我们建议您更改默认根目录和管理员
初始配置期间的密码。
警告：这是a类设备。该设备可能会导致无线电故障
干扰居民区，运营商可能需要采取适当措施
措施。
启动
8334_en_02菲尼克斯电气25
3.5安装FL MGUARD PCI4000
3.5.1安装硬件
FL MGUARD PCI4000：结构
图3-4 FL MGUARD PCI4000结构
将FL MGUARD PCI4000安装在免费PCI插槽中。请遵守文档中的注释
对于您的系统。

Woodward 8924-574

Woodward 8924-574

LAN port Ethernet connector for direct connection to the device or network to be protected (local device or network). USB connector For connection to the USB interface of a computer. For the power supply (default settings). The FL MGUARD SMART2 (not the FL MGUARD SMART) can be configured such that a serial console is available via the USB connector (see Section 5.3.1.5). WAN port Socket for connection to the external network, e.g., WAN, Internet. (Connections to the remote device or network are established via this network.) Use a UTP cable (CAT5). Before: After: (A LAN can also be on the left.) If your computer is already connected to a network, insert the FL MGUARD SMART2 between the network interface of the computer (i.e., its network card) and the network. Driver installation is not required. For security reasons, we recommend you change the default root and administrator passwords during initial configuration. WARNING: This is a Class A item of equipment. This equipment can cause radio interference in residential areas, and the operator may be required to take appropriate measures. Startup 8334_en_02 PHOENIX CONTACT 25 3.5 Installing the FL MGUARD PCI4000 3.5.1 Installing the hardware FL MGUARD PCI4000: structure Figure 3-4 FL MGUARD PCI4000 structure Install the FL MGUARD PCI4000 in a free PCI slot. Observe the notes in the documentation for your system.

n