1X00126H01模块备件

1X00126H01

信使
用于系统输出（例如，屏幕显示、报告），
示例和系统提示。
十八
<Enter>、<Return>或<CR>
表示回车键或回车键。
Ctrl键
表示控制键。按执行控制字符
Ctrl键和字母同时显示，例如Ctrl-d。
1-1
1硬件准备和
安装
介绍
本章包含以下信息：
❏ 电路板准备和安装说明
❏ ESD注意事项
描述
MVME6100是基于
MPC7457处理器、MV64360系统控制器、Tsi148 VME
桥接ASIC，多1GB受ECC保护的DDR DRAM，多128MB
闪存和双千兆以太网接口。
MVME6100板上的前面板连接器包括：两个RJ-45
用于千兆以太网的连接器，一个RJ-45连接器用于
带集成LED的异步串行端口，用于BRDFAIL和CPU运行
以及组合复位和中止开关。
MVME6100附带一个额外的异步串行端口
路由到板载标题。
MVME6100包含两个支持PCI-X的IEEE1386.1 PCI
夹层卡插槽。PMC插槽具有64位功能，并支持这两种功能
前后输入/输出。PMC插槽1的所有I/O引脚和PMC插槽的46个I/O针脚
2连接到5排DIN P2连接器。来自的I/O引脚1到64
PMC插槽1的J14路由到P2的C行和A行。I/O引脚1至
46被路由到P2的行D和行Z。
MVME6100具有两条平面PCI总线（PCI0和PCI1）。为了
支持更通用的PCI总线层次命名法MV64360
PCI总线在本文件中称为PCI总线0（根桥
实例0，总线0）和PCI总线1（根网桥实例1，总线0）。PCI总线1
连接到板的PMC插槽1和2。PCI总线0连接到
Tsi148 VME桥ASIC和PMCspan桥（PCI6520）。这个接口

1X00126H01

1X00126H01

courier is used for system output (for example, screen displays, reports), examples, and system prompts. xviii , or represents the carriage return or Enter key. Ctrl represents the Control key. Execute control characters by pressing the Ctrl key and the letter simultaneously, for example, Ctrl-d. 1-1 1 1Hardware Preparation and Installation Introduction This chapter contains the following information: ❏ Board preparation and installation instructions ❏ ESD precautionary notes Description The MVME6100 is a single-slot, single-board computer based on the MPC7457 processor, the MV64360 system controller, the Tsi148 VME Bridge ASIC, up to 1 GB of ECC-protected DDR DRAM, up to 128MB of flash memory, and a dual Gigabit Ethernet interface. Front panel connectors on the MVME6100 board include: two RJ-45 connectors for the Gigabit Ethernet, one RJ-45 connector for the asynchronous serial port with integrated LEDs for BRDFAIL and CPU run indication, and a combined reset and abort switch. The MVME6100 is shipped with one additional asynchronous serial port routed to an on-board header. The MVME6100 contains two IEEE1386.1 PCI, PCI-X capable mezzanine card slots. The PMC slots are 64-bit capable and support both front and rear I/O. All I/O pins of PMC slot 1 and 46 I/O pins of PMC slot 2 are routed to the 5-row DIN, P2 connector. I/O pins 1 through 64 from J14 of PMC slot 1 are routed to row C and row A of P2. I/O pins 1 through 46 from J24 of PMC slot 2 are routed to row D and row Z of P2. The MVME6100 has two planar PCI buses (PCI0 and PCI1). In order to support a more generic PCI bus hierarchy nomenclature, the MV64360 PCI buses will be referred to in this document as PCI bus 0 (root bridge instance 0, bus 0) and PCI bus 1 (root bridge instance 1, bus 0). PCI bus 1 connects to PMC slots 1 and 2 of the board. PCI bus 0 connects to the Tsi148 VME Bridge ASIC and PMCspan bridge (PCI6520). This interfac