1X00416H04模块备件

1X00416H04

开箱指南
将设备从装运箱中取出。请参阅装箱单
并验证是否存在所有项目。保存包装材料以备储存
以及设备的重新装运。
注意：如果装运纸箱在收到时损坏，请要求
开包和检查期间，承运人代理人应在场
设备。
!
小心
注意：避免接触集成电路的区域；静电放电会损坏
电路。
使用静电放电
腕带
ESD摩托罗拉强烈建议您使用防静电腕带和
安装或升级系统时使用导电泡沫垫。电子的
组件，如磁盘驱动器、计算机板和内存模块
对静电放电（ESD）极为敏感。之后
将部件从其保护包装或从系统中移除，
将部件平放在接地的无静电表面上（在这种情况下
元件侧朝上）。不要将部件滑动到任何位置
表面
如果ESD站不可用，您可以避免因以下原因造成的损坏：
通过佩戴防静电腕带进行ESD（可在电子商店购买）
其连接到有源电接地。请注意，系统机箱
如果拔下，可能不会接地。
!
小心
注意：在通电的情况下插入或移除模块可能会导致损坏
到模块组件。
警告
警告：本系统中存在可能导致死亡的危险电压
设备搬运、测试和调整时应格外小心
1X00416H04

1X00416H04

Unpacking Guidelines Unpack the equipment from the shipping carton. Refer to the packing list and verify that all items are present. Save the packing material for storing and reshipping of equipment. Note If the shipping carton is damaged upon receipt, request that the carrier’s agent be present during the unpacking and inspection of the equipment. ! Caution Caution Avoid touching areas of integrated circuitry; static discharge can damage circuits. Use ESD Wrist Strap ESD Motorola strongly recommends that you use an antistatic wrist strap and a conductive foam pad when installing or upgrading a system. Electronic components, such as disk drives, computer boards, and memory modules can be extremely sensitive to electrostatic discharge (ESD). After removing the component from its protective wrapper or from the system, place the component flat on a grounded, static-free surface (and, in the case of a board, component side up). Do not slide the component over any surface. If an ESD station is not available, you can avoid damage resulting from ESD by wearing an antistatic wrist strap (available at electronics stores) that is attached to an active electrical ground. Note that a system chassis may not be grounded if it is unplugged. ! Caution Caution Inserting or removing modules with power applied may result in damage to module components. Warning Warning Dangerous voltages, capable of causing death, are present in this equipment. Use extreme caution when handling, testing, and adjusting