5X00128G01 模块备件

5X00128G01 

5X00128G01 X75快速I/O输入（完整版）尚不可用
X76快速I/O输出（完整版）尚不可用
X77快速I/O输入（完整版）尚不可用
X80模拟输入（来自CT和/或VT）连接器套件强制c/w 24触点
-短版本代码350.040.902
-长版本代码350.040.903
用手动工具压接任何单个触点
编号：350.048.011
X81..88模拟输入（传感器通道1..8）BNC双凸轮CPE 23.717.140-0333
表3：用于SPABUS连接的中央单元上的连接器，电气RS232（修改）
连接器说明：连接器插头类型
X60 RS232（修改）9针D-sub公接头（z-modem）
注：RS232连接器，经过改进和电流隔离，可用于连接到
LON/SPA网关。
表4：用于SPABUS连接的中央单元上的连接器，塑料光纤电缆
连接器说明：连接器插头类型
X60 TX（光接口）卡入式HP HFBR 4501（灰色）
X61 RX（光接口）卡入式HP HFBR 4511（蓝色）
注意：使用塑料光纤电缆连接SPABUS的电缆长度应：
不超过30米
REF 542plus开关间保护和控制单元
手册第3部分：安装和调试
1VTA10004 en DMS，2001-10-04参考542 Plus：安装和调试19/80
表5：用于SPABUS连接的中央单元上的连接器，玻璃纤维光缆
连接器说明：连接器插头类型
X60 TX（光学接口）ST插头HITRONIC ST-125
X61 RX（光学接口）ST插头HITRONIC ST-125
注意：SPABUS与玻璃纤维光缆连接的电缆长度应：
不超过1000米
表6：分别符合IEC 60870-5-103中LAG 1.4的LON中央单元上的连接器
连接器说明：连接器插头类型
X60 TX（光学接口）ST插头HITRONIC ST-125
X61 RX（光学接口）ST插头HITRONIC ST-125
警告：LON（根据LAG 1.4）与玻璃纤维光缆连接的电缆长度不得超过2000 m
表7：MODBUS RTU中央单元上的连接器，电气RS485
连接器说明：连接器插头类型
X60 RS485通道1 2英寸魏德穆勒-布拉特2BSNOR
X61 RS485通道2英寸魏德穆勒-布拉特2Bsnor
注意：使用MODBUS RTU a扭曲连接到上层自动化系统
应使用成对电缆。如果电缆被屏蔽，则仅连接
屏蔽至外壳的接地螺钉。大波特率为115000
比特/秒。电缆长度不应超过130米
表8：MODBUS、玻璃纤维光缆中央单元上的连接器
连接器说明：连接器插头类型
X62 RX信道1（光接口）ST插头HP型HFBR*XS*
X63 TX信道1（光接口）ST插头HP型HFBR*XS*
X64 RX信道2（光接口）ST插头HP型HFBR*XS*
X65 TX信道2（光接口）ST插头HP型HFBR*XS*
警告：glas的大波特率为115000位/秒

5X00128G01 

X75 Fast I/O inputs (full version) Not available yet
X76 Fast I/O outputs (full version) Not available yet
X77 Fast I/O inputs (full version) Not available yet
X80 Analog inputs (from CT and/or VT) Connector kit Compel c/w 24 contacts
- Short version code 350.040.902
- Long version code 350.040.903
Crimp any single contact with hand tool
No 350.048.011
X81..88 Analog input (sensor channel 1..8) BNC Twin Cam CPE 23.717.140-0333
Table 3: Connectors on Central Unit for SPABUS connection, electrical RS232 (modified)
Connector Descriptions Type of connector plug
X60 RS232 (modified) 9 pin D-sub connector male (z-modem)

Note The RS232 connector, modified and galvanic isolated, can be applied to connect to a
LON/SPA gateway.
Table 4: Connectors on Central Unit for SPABUS connection, plastic fiber optical cable
Connector Descriptions Type of connector plug
X60 TX (optical interface) Snap in HP HFBR 4501 (gray)
X61 RX (optical interface) Snap in HP HFBR 4511 (blue)

Caution The cable length for SPABUS connection with plastic fiber optical cable should
not exceed 30 m 
REF 542plus switchbay protection and control unit
Manual Part 3: Installation and Commissioning
1VTA100004-en DMS,2001-10-04 REF542plus: Installation and Commissioning 19 / 80
Table 5: Connectors on Central Unit for SPABUS connection, glass fiber optical cable
Connector Descriptions Type of connector plug
X60 TX (optical interface) ST plug HITRONIC ST-125
X61 RX (optical interface) ST plug HITRONIC ST-125

Caution The cable length for SPABUS connection with glass fiber optical cable should
not exceed 1000 m
Table 6: Connectors on Central Unit for LON per LAG 1.4 respectively IEC 60870-5-103
Connector Descriptions Type of connector plug
X60 TX (optical interface) ST plug HITRONIC ST-125
X61 RX (optical interface) ST plug HITRONIC ST-125

Caution The cable length for LON (per LAG 1.4) connection with glass fiber optical cable should not exceed 2000 m
Table 7: Connectors on Central Unit for MODBUS RTU, electrical RS485
Connector Descriptions Type of connector plug
X60 RS485 channel 1 2pin Weidmueller BLAT2BSNOR
X61 RS485 channel 2 2pin Weidmueller BLAT2BSNOR

Caution To connect to the upper level automation system with MODBUS RTU a twisted
pair cable shall be used. If the cable is shielded, connect only one side of the
shield to the earth screw of the housing. The maximum baud rate is 115000
bit/s. The cable length should not exceed 130 m
Table 8: Connectors on Central Unit for MODBUS, glass fiber optical cable
Connector Descriptions Type of connector plug
X62 RX channel 1 (optical interface) ST plug HP type HFBR *XS*
X63 TX channel 1 (optical interface) ST plug HP type HFBR *XS*
X64 RX channel 2 (optical interface) ST plug HP type HFBR *XS*
X65 TX channel 2 (optical interface) ST plug HP type HFBR *XS*

Caution The maximum baud rate is 115000 bit/s with glas