DH664UDKW3 用于模拟量控制器DCS控制柜 CUTLER HAMMER

产品标题：DH664UDKW3 用于模拟量控制器DCS控制柜 CUTLER HAMMER

型号：DH664UDKW3 用于模拟量控制器DCS控制柜  

品牌： CUTLER HAMMER

质保：七天验收期，质保期一年
发货期：1-3个工作日

产品图片展示

产品详情资料

对DCS 500电源部分进行oring
检测器用于上述（a.）和（b.），但
不是安装在散热器上，而是安装在
装置外壳位于上部进气区。这个
因此，探测器测量功率部分的
辐射热和冷却空气中的任何变化
温度和体积。由于冷却空气
只能间接检测容积，另外安装了压差开关
在单位的住房。
电阻变化与
在中获取和评估温度
该单元的软件。如果温度高于
参数化值，则首先报警
输出，如果温度持续
上升-错误消息。要设置的值
该参数不得高于允许环境温度10度以上。
压差开关比较
装置内的压力为正常大气压。如果风扇已打开
机组门关闭（无机组外壳）
已拆下），压力开关将
信号“冷却条件正常”，表示
驱动器可能已启用。没有必要设置
任何特定压差（建议：中心设置）。
a、 尺寸为C1和C2的功率段为：
由电气隔离PTC热敏电阻检测器监控，该检测器安装在
晶闸管附近的电隔离散热器。
电阻变化与
在中获取和评估温度
该单元的软件。如果温度高于
单位编码预定义的特定值
则首先将输出警报，
如果温度继续上升，则
错误消息。这意味着
额定冷却条件，如冷却空气
体积和温度、风扇本身、过载
由于过高的负载电流等
检测。
b、 同样，对尺寸为C3的功率段进行监控
通过安装在非隔离热上的电隔离PTC热敏电阻检测器
通过
适配器板和隔离盘。评价
电阻和保护效果对应于上文（a.）点所述的电阻和保护效应。
c、 尺寸为C4的电源部分不直接由电隔离PTC热敏电阻监控
探测器对于这种尺寸，相同的热敏电阻Orient the DCS 500 power supply
The detector is used for (a.) and (b.) above, but
Not on the radiator, but on the
The unit housing is located in the upper intake area. this
Therefore, the detector measures the
Any change in radiant heat and cooling air
Temperature and volume. Due to cooling air
The volume can only be detected indirectly, and a differential pressure switch is additionally installed
Housing in the unit.
Resistance variation vs
Obtain and evaluate temperature in
The software of the unit. If the temperature is higher than
Parameterized value, alarm first
Output, if temperature continues
Rise - Error message. Value to set
This parameter shall not be higher than the allowable ambient temperature by more than 10 degrees.
Differential pressure switch comparison
The pressure in the unit is normal atmospheric pressure. If the fan is turned on
Unit door closed (without unit housing)
Removed), the pressure switch will
The signal "cooling condition is normal" indicates
The drive may be enabled. No necessary settings
Any specific differential pressure (recommended: center setting).
a. The power bands of sizes C1 and C2 are:
Monitored by an electrically isolated PTC thermistor detector mounted on the
Electric isolation radiator near the thyristor.
Resistance variation vs
Obtain and evaluate temperature in
The software of the unit. If the temperature is higher than
Specific values predefined by the unit code
The alarm will be output first,
If the temperature continues to rise
Error message. This means
Rated cooling conditions, such as cooling air
Volume and temperature, fan itself, overload
Due to excessive load current, etc
testing.
b. Similarly, monitor the power band with size C3
By electrically isolated PTC thermistor detector mounted on non isolated heat
adopt
Adapter plate and isolation plate. evaluate
The resistance and protection effect correspond to the resistance and protection effect described in point (a.) above.
c. The power supply part with size C4 is not directly monitored by the electrically isolated PTC thermistor
Detector For this size, the same thermistor

主营产品简介
专注于DCS、PLC、机器人控制系统、大型伺服四大系统领域。

主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。

优势：供应进口原装正品，专业停产配件，

发货快，货期精准，

主营品牌包括 ABB贝利、GE/FUANC、FOXBORO、英维思TRICONEX 、本特利BENTLY、A-B罗克韦尔、艾默生EMERSON 、OVATION、MOTOROLA、XYVOM、霍尼韦尔HONEYWELL 、力士乐REXROTH、KUKA、NI、DEIF、横河、伍德沃德WOODWARD、瑞恩、施耐德SCHNEIDER 、安川、 穆格MOOG、PROSOFT等品牌