DS200IIBDG1AEA DS200IIBDG1A 用于模拟量数据扩展卡 GE

产品标题：DS200IIBDG1AEA DS200IIBDG1A 用于模拟量数据扩展卡 GE

型号：DS200IIBDG1AEA DS200IIBDG1A 用于模拟量数据扩展卡 

品牌：  GE

质保：七天验收期，质保期一年
发货期：1-3个工作日

产品图片展示

产品详情资料

DCS转换器模块的电源接口
900 A至5150 A的C3和C4型包括：
两个板中的一个-测量板SDCS-PIN-5x
以及脉冲变压器板SCDS-PIN-41。
SDCS-PIN-5x有不同的版本：
用于所有线电压转换器的SDCS-PIN-51
带线路电压的转换器的SDCS-PIN-52。500伏
下图显示了SDCS引脚41和SDCS引脚5x之间的不同连接
板取决于应用2象限或4象限和结构类型。
测量板SDCS-PIN-5x
该板始终与SDCSPIN-41板一起使用。电路板上有电路
用于电流、电压和温度测量以及硬件编码。
电流由以下位置的电流互感器测量：
由二极管电桥整流的交流电源
用负载电阻将额定电流定为1.5 V。通过切割调整电流响应
根据从电路板输出电阻器（R1…R21）
到编码表。电阻器R22…R26为：
用于电流等于零的检测。这些
必须根据第二个表切断电阻器。
电压（U1、V1、W1和C1（+）和D1（-）为
通过使用高欧姆电阻链测量。交流和直流电压的缩放通过激活1完成
脉冲变压器板SDCS-PIN-41/PIN-41A
图5.4/5线电压转换器的SDCS-PIN-51板布局>500伏
M
电阻器（=切断短路导线
由低欧姆电阻表示）。
对于电压测量，5个电阻链为：
电压自适应，所有5条链
必须以相同的方式处理。
当需要隔离测量时，
请继续The Power Interface of DCS converter modules
model C3 and C4 from 900 A up to 5150 A consists
of two boards - the Measuring board SDCS-PIN-5x
and the Pulse transformer board SCDS-PIN-41.
There are different versions of the SDCS-PIN-5x:
SDCS-PIN-51 for converters with all line voltages
SDCS-PIN-52 for converters with line volt.
500 V
The following figures show the different connections between the SDCS-PIN-41 and SDCS-PIN-5x
board depending on the application 2- or 4-quadrant and the construction type.
Measuring board SDCS-PIN-5x
This board is always used together with SDCSPIN-41 board. On this board there are the circuits
located needed for current, voltage and temperature measuring and for hardware coding.
The current is measured by current transformers at
the AC supply, rectified by a diode bridge and
scaled with burden resistors to 1.5 V as rated current. The current response is adjusted by cutting
out resistors (R1 ... R21) from the board according
to the coding table. The resistors R22 ... R26 are
used for the current equal to zero detection. These
resistors must be cut off according to a second table.
Voltages (U1, V1, W1 and C1(+) and D1(-)) are
measured by using high ohm resistor chains. Scaling of AC and DC voltage is done by activating 1
Pulse transformer board SDCS-PIN-41/PIN-41A
Fig. 5.4/5 Layout of the SDCS-PIN-51 board for converters with line volt. >500 V
M
resistors (= cutting out short circuit wires, which
are represented by a low ohmic resistance).
For the voltage measurement 5 resistor chains are
 oltage adaption, all 5 chains
must be handled in the same way.
When gavanically isolated measurement is needed,
please cont

主营产品简介
专注于DCS、PLC、机器人控制系统、大型伺服四大系统领域。

主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。

优势：供应进口原装正品，专业停产配件，

发货快，货期精准，

主营品牌包括 ABB贝利、GE/FUANC、FOXBORO、英维思TRICONEX 、本特利BENTLY、A-B罗克韦尔、艾默生EMERSON 、OVATION、MOTOROLA、XYVOM、霍尼韦尔HONEYWELL 、力士乐REXROTH、KUKA、NI、DEIF、横河、伍德沃德WOODWARD、瑞恩、施耐德SCHNEIDER 、安川、 穆格MOOG、PROSOFT等品牌