D-373024-28 用于控制PLC系统运行终端输入键盘 FORNEY

产品标题：D-373024-28 用于控制PLC系统运行终端输入键盘 FORNEY

型号：D-373024-28 用于控制PLC系统运行终端输入键盘  

品牌：  FORNEY

质保：七天验收期，质保期一年
发货期：1-3个工作日

产品图片展示

产品详情资料

备件
电源部分的保护通过以下方式完成：
RC和缓冲电路。缓冲器电路由保险丝F71、F72和F73保护。交流电压
从保险丝后面进行测量。
保险丝数据：Ferraz 25 A/660 V；
6621型CP URD 22.58 Q/25功率部分的散热器温度
一些DCS转换器通过PTC元件进行监控。其他DCS转换器检查冷却空气
温度和气流。第三种选择是：
一个，用于测量风扇电流
限制。如果风扇电流过低或
根本没有风扇电流或风扇电流过高，驱动器需要
关闭。风扇电流可能过低
因为
-风扇可能未打开，或
数据
交流输入/输出电压：单相；230伏
交流输入/输出电流：5A
交流峰值电流：根据风机启动电流；需要外部开关设备
交流隔离电压：690 V（通过自耦变压器供电）
负载：带启动电容器的单相交流电机
频率：50 Hz/60 Hz
输出数据：无源器件；仅与DCS电子设备一起使用
端子截面积：X92：电源；大2.5 mm2
X11：至X31：电机连接；6.3毫米faston
电流缩放：负载电阻R100/R101；R100/R101=120
互连：参见部分电源部分DCP变流器的冷却
5.9.1 PW 1002
本设备的设计和使用专用于：
默认情况下，直接高于800 A的DCP转换器
条件它由230 V单相供电
电源和将监控两个单相
并联安装在转换器顶部的风扇
配置传输特性是相同的
与PW 1003中描述的相同
本手册中的电源部分冷却显示
电源和
风扇和接口板PG 7xx3。
-风机电源内的任何保护装置具有：
行动或
-电线断了，或
-螺旋桨松动或类似的东西
风扇电流可能过高，因为：
-风扇可能被机械堵塞，或
-风扇绕组短路或类似故障
加速期间的过电流可由  Spare part
The protection of the power part is done by using
RC and snubber circuits. The snubber circuit is protected by fuses F71, F72 and F73. The AC voltage
measurement is taken from behind the fuse.
Fuse data: Ferraz 25 A/660 V;
Type 6,621 CP URD 22.58 Q/25The heatsink temperature of the power part of
some DCS converters is monitored via a PTC element. Other DCS converters check the cooling air
temperature and the airflow. The third option is this
one, which measures the fan current being within
limits. In case the fan current is too low or there is
no fan current at all or it is too high, the drive needs
to be switched off. The fan current may be too low
because
- the fan may not be switched on or
Data
AC input / output voltage: single phase; 230 V
AC input / output current: 5 A
AC peak current: according to fan starting current; external switching device needed
AC isolation voltage: 690 V (supply via autotransformer)
Load: single phase AC motors with starting capacitor
Frequency: 50 Hz / 60 Hz
Output data: passive device; to be used together with DCS electronics only
Terminal cross sectional area: X92: power supply; max. 2.5 mm2
X11: to X31: motor connection; 6.3 mm faston
Current scaling: burden resistor R100 / R101; R100/R101 = 120
each
Interconnection: See part power section cooling of DCP converters
5.9.1 PW 1002
This device is designed and used exclusively at
DCP converters above 800 A directly in default
condition. It is supplied by a 230 V single phase
power supply and will monitor the two single phase
fans mounted on top of the converter in parallel
configuration. The transfer characteristic is identical
to the one described at the PW 1003. The part
power section cooling within this manual shows the
interconnections between the power supply, the
fans and the interface board PG 7xx3.
- any protection device within the fan supply has
acted or
- a wire is broken or
- the propeller became loose or something similar
The fan current may be too high because
- the fan may be blocked mechanically or
- there is a short circuit in the fan winding or something similar
The overcurrent during acceleration can be supp

主营产品简介
专注于DCS、PLC、机器人控制系统、大型伺服四大系统领域。

主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。

优势：供应进口原装正品，专业停产配件，

发货快，货期精准，

主营品牌包括 ABB贝利、GE/FUANC、FOXBORO、英维思TRICONEX 、本特利BENTLY、A-B罗克韦尔、艾默生EMERSON 、OVATION、MOTOROLA、XYVOM、霍尼韦尔HONEYWELL 、力士乐REXROTH、KUKA、NI、DEIF、横河、伍德沃德WOODWARD、瑞恩、施耐德SCHNEIDER 、安川、 穆格MOOG、PROSOFT等品牌