80190-300-01-R 80190-299-01D 用于处理器模块输入输出 A-B

产品标题：1070071219-102 1070065599-102 1070062860-106 控制卡 Bosch

型号： 1070071219-102 1070065599-102 1070062860-106 控制卡 

品牌：  Bosch

质保：七天验收期，质保期一年
发货期：1-3个工作日

产品图片展示

产品详情资料

a、 尺寸为C1和C2的功率段为：
由电气隔离PTC热敏电阻检测器监控，该检测器安装在
晶闸管附近的电隔离散热器。
电阻变化与
在中获取和评估温度
该单元的软件。如果温度高于
单位编码预定义的特定值
则首先将输出警报，
如果温度继续上升，则
错误消息。这意味着
额定冷却条件，如冷却空气
体积和温度、风扇本身、过载
由于过高的负载电流等
检测。
b、 A5尺寸的电源部分也同样受到监控
通过安装在非隔离热上的电隔离PTC热敏电阻检测器
处于隔离配置的接收器。评价
电阻和保护效果对应于上文（a.）点所述的电阻和保护效应。
c、 A6和A7功率段的尺寸不直接
由电隔离PTC热敏电阻检测器监测。对于这种尺寸，使用与上述（a）和（b）相同的热敏电阻检测器。此处，热敏电阻检测器不安装在散热器上，但靠近
风扇出风口。检测器因此测量
功率部分的辐射热和任何变化
在冷却空气温度和体积。自从
只能检测冷却空气量
间接地，压差开关已经
额外安装在装置外壳上，始终
靠近电源端子。
电阻变化与
在中获取和评估温度
该单元的软件。如果温度高于
参数化值，则首先报警
输出，如果温度持续
上升-错误消息。要设置的值
该参数不得高于允许环境温度10度以上。
压差开关比较
装置内的压力为正常大气压。如果风扇已打开
机组门关闭（无机组外壳）
已拆下），压力开关将
信号“冷却条件正常”，表示
驱动器可能已启用。没有必要设置
任何特定压差（建议：中心设a.The power sections of sizes C1 and C2 are
monitored by an electrically isolated PTC thermistor detector, which is installed on the likewise
electrically isolated heat sink near the thyristors.
The resistance change proportional to the
temperature is acquired and evaluated in the
unit’s software. If the temperature rises above a
certain value predefined by the unit coding
involved, then first an alarm will be outputted,
and - if the temperature continues to rise - an
error message. This means that changes in the
rated cooling conditions, such as cooling air
volume and temperature, the fan itself, overload
due to an excessively high load current, etc. are
detected.
b.The size-A5 power section is likewise monitored
by an electrically isolated PTC thermistor detector, which is installed on the non-isolated heat
sink in an isolated configuration. Evaluation of
the resistance and the protection effect correspond to those mentioned for point (a.) above.
c. The size A6 and A7 power section is not directly
monitored by an electrically isolated PTC thermistor detector. For this size, the same thermistor detector is used as for (a.) and (b.) aboveit is here not mounted on a heat sink but close to
the fan air outlet. The detector thus measures the
power section’s radiated heat and any changes
in the cooling air temperature and volume. Since
the cooling air volume can only be detected
indirectly, a differential-pressure switch has been
additionally fitted at the unit’s housing, always
located close to the power terminals.
The resistance change proportional to the
temperature is acquired and evaluated in the
unit’s software. If the temperature rises above the
parameterized value, then first an alarm will be
outputted, and - if the temperature continues to
rise - an error message. The value to be set for
this parameter must not be more than 10 degrees above the permissible ambient temperature.
The differential-pressure switch compares the
pressure inside the unit with the normal atmospheric pressure. If the fan has been switched on
and the unit door closed (and no unit casings
have been removed), the pressure switch will
signal “Cooling conditions ok”, which means the
drive may be enabled. There is no need to set
any specific differential pressure (recommendation: centre setting).
置）。
ris

主营产品简介
专注于DCS、PLC、机器人控制系统、大型伺服四大系统领域。

主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。

优势：供应进口原装正品，专业停产配件，

发货快，货期精准，

主营品牌包括 ABB贝利、GE/FUANC、FOXBORO、英维思TRICONEX 、本特利BENTLY、A-B罗克韦尔、艾默生EMERSON 、OVATION、MOTOROLA、XYVOM、霍尼韦尔HONEYWELL 、力士乐REXROTH、KUKA、NI、DEIF、横河、伍德沃德WOODWARD、瑞恩、施耐德SCHNEIDER 、安川、 穆格MOOG、PROSOFT等品牌