5460-570 SPEED REFERENCE 速度检测模块 WOODWARD

产品标题：5460-570 SPEED REFERENCE 速度检测模块 WOODWARD

型号： 5460-570 SPEED REFERENCE 速度检测模块 

品牌：  WOODWARD

质保：七天验收期，质保期一年
发货期：1-3个工作日

产品图片展示

产品详情资料

  如果要浇注的垫层将用作外露或抛光磨损表面，则取
以下预防措施，以限制USG Durock可能导致的成品表面瑕疵™ EW2型
底层表面涂底漆：
•至少需要1小时的固化时间。USG杜洛克™ EW2底漆应发粘，但不发粘
安装衬底前，请触摸“潮湿”。
•使用计量耙或销辊可能会将过量或未固化的底漆带到
垫层。不要刮伤基材或USG Durock™ EW2底漆
垫层；只要用浮子打破表面张力。
1.必须适用于适当准备的干净板。表面可能潮湿，但没有
底漆涂敷时出现积水或反光。
2.USG杜洛克™ EW2底漆不是水分控制膜，不应用于
本身就是一种水分缓解解决方案。MVER超过4磅（1.8千克）/1000平方英尺时。
（92.9平方米
)/24小时，用USG Durock处理混凝土底层地板™ 品牌湿气
减速器。过多的水蒸气或水分从混凝土底层地板通过
USG杜洛克™ EW2底漆和USG Durock™ 或USG Levelrock垫层可能会干扰
使用表面涂层或地板覆盖粘合剂，并降低其性能。
3.不要使用膨胀接头或隔离接头。继续混凝土板中的所有移动接缝
向上穿过垫层。在伸缩缝或隔离缝不存在的区域
出现在地板上或混凝土板因
板坯移动，就项目咨询工程师或请求专业人员提供服务
结构工程师根据工程要求提供此类接头作为系统的一部分
要求和行业标准。
4.新旧混凝土中存在的裂缝必须用适当的裂缝进行修补
在安装
底漆。注意，混凝土底层楼板中现有裂缝的修复只会减弱但不会
完全阻止他们通过美国杜洛克电报™ EW2底漆和地板
垫层。混凝土底层楼板中现有裂缝的扩展或新裂缝的形成
会导致裂纹teIf the underlayment to be poured will be used as an exposed or polished wear surface, take the
following precautions to limit finished surface blemishes that may result if USG Durock™ EW2
Primer is worked to the surface of the underlayment:
• A minimum cure time of 1 hour is required. USG Durock™ EW2 Primer should be tacky, but not
“wet” to the touch before installing the underlayment.
• The use of gauge rakes or pin rollers may bring excess or uncured primer to the surface of the
underlayment. Do not scrape the substrate or USG Durock™ EW2 Primer when smoothing the
underlayment; just break the surface tension with the float.
1. Must be applied to a properly prepared clean slab. The surface may be damp but with no
standing or glistening water at time of primer application.
2. USG Durock™ EW2 Primer is not a moisture control membrane and should not be used by
itself as a moisture mitigation solution. When the MVER exceeds 4 lbs. (1.8 kg)/1,000 sq. ft.
(92.9 m2
)/24 hours, treat the concrete subfloor with a USG Durock™ Brand Moisture Vapor
Reducer. Transmission of excessive water vapor or moisture from the concrete subfloor through
the USG Durock™ EW2 Primer and USG Durock™ or USG Levelrock underlayment can interfere
with topical coatings or floor-covering adhesives and compromise their performance.
3. Do not use over expansion or isolation joints. Continue all movement joints in the concrete slab
up through the layer of underlayment. In areas where the expansion or isolation joints are not
present in the floor or where the concrete slab has developed systematic cracks in response to
slab movement, consult with an engineer on the project or request services of a professional
structural engineer to provide such joints as part of the system in accordance with engineering
requirements and industry standards.
4. Existing cracks in the new and old concrete must be repaired with an appropriate crack
repair material in accordance with industry recommendations prior to installation of the
primer. Note that repair of existing cracks in the concrete subfloor only subdues but does not
completely prevent their ability to telegraph through USG Durock™ EW2 Primer and the floor
underlayment. Growth of existing cracks or formation of new cracks in the concrete subfloor
can lead to cracks te

主营产品简介
专注于DCS、PLC、机器人控制系统、大型伺服四大系统领域。

主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。

优势：供应进口原装正品，专业停产配件，

发货快，货期精准，

主营品牌包括 ABB贝利、GE/FUANC、FOXBORO、英维思TRICONEX 、本特利BENTLY、A-B罗克韦尔、艾默生EMERSON 、OVATION、MOTOROLA、XYVOM、霍尼韦尔HONEYWELL 、力士乐REXROTH、KUKA、NI、DEIF、横河、伍德沃德WOODWARD、瑞恩、施耐德SCHNEIDER 、安川、 穆格MOOG、PROSOFT等品牌