使用流程 3BSC690086R1

产品标题：AI895 3BSC690086R1特惠数字量控制卡

型号：AI895 3BSC690086R1

品牌：ABB

质保：七天验收期，质保期一年
发货期：1-3个工作日

产品图片展示

产品详情资料
•组件选择
对于此接线图，选择了C1或C2型DCF 500B转换器结构以及用作过电压的DCF 506装置
保护
•电源
有几个组件需要电源：
-转换器的电源部分：200 V至500 V，取决于转换器类型；见第2章
-转换器电子电源：115 V或230 V，由跳线选择
-变频器冷却风扇：230 V 1-ph，C1+C2；见技术数据
-继电器逻辑：取决于本地需求
基本上如图3.1/1所示。如果变频器直接由C点的高压变频器变压器供电，请确保高压
只要励磁电流流动，开关就不会断开。驱动器工程设计期间应考虑其他条件（如有要求，请提供更多信息）。
•控制
继电器逻辑可分为三部分。
a： ON/OFF和START/STOP命令的生成：与图3.1/1相同
b： 控制和监测信号的生成：基本上与图3.1/1相同。
在二进制输入2处监控电机风扇（此处不存在，但可能作为电感的冷却装置存在），而不是通过相同的输入监控过压保护DCF 506。如果需要监控任何类型的附加冷却装置，则可以
习惯于
c： ON/OFF和START/Stop旁边的停止模式：基本上与图3.1/1相同
在这种情况下，关注电流的减少可能比关注其他事情更重要。如果是，则在参数下选择滑行
紧急停止模式。
•排序• Selection of components
For this wiring diagram a DCF 500B converter construction type C1 or C2 was selected together with a DCF 506 unit, which serves as an overvoltage
protection.
• Power supply
There are several components, which need a power supply:
- Converter´s power part: 200 V to 500 V, depending on converter type; see chapter 2
- Converters electronics power supply: 115 V or 230 V, selected by jumper
- Converter cooling fan: 230 V 1-ph at C1 + C2; see Technical Data
- Relay logic: depending on local demands
Basically according to figure 3.1/1. If the converter is supplied directly by a high-voltage converter transformer at point C , make sure that the high voltage
switch is not opened, as long as field current flows. Additional conditions are to be considered during engineering of the drive (further information on request).
• Control
The relay logic can be split into three parts.
a: Generation of the ON/OFF and START/STOP command: same as figure 3.1/1
b: Generation of control and monitoring signals: Basically identical to figure 3.1/1.
Instead of the monitoring of the motor fan at binary input 2, which is not existing here but may exist as a cooling device for the inductance, the overvoltage protection DCF 506 is monitored by the same input. If any type of additional cooling device should be monitored extra function blocks can be
used.
c: Stop mode beside ON/OFF and START/STOP: Basically identical to figure 3.1/1
In this case it may be much more important to focus on a reduction of the current than on something else. If so, select coasting at the parameter
EMESTOP_MODE.
• Sequencing
same as figure 3.1/1
同图3.1/1
  主营产品简介

专注于DCS、PLC、机器人控制系统、大型伺服四大系统领域。

主营产品各种模块/卡件，控制器，触摸屏，伺服驱动器。

优势：供应进口原装正品，专业停产配件，

发货快，货期精准，

主营品牌包括 ABB贝利、GE/FUANC、FOXBORO、英维思TRICONEX 、本特利BENTLY、A-B罗克韦尔、艾默生EMERSON 、OVATION、MOTOROLA、XYVOM、霍尼韦尔HONEYWELL 、力士乐REXROTH、KUKA、NI、DEIF、横河、伍德沃德WOODWARD、瑞恩、施耐德SCHNEIDER 、安川、 穆格MOOG、PROSOFT等品牌