初始显示R0:03空>S要将IC693ALG392模块添加到配置中，请按读取/验证、ENT键序列。将显示以下屏幕：R0:03 AO 1.00>S I16:I_选择%I参考此时，必须输入从模块返回的状态数据的起始%I参考地址。请注意，状态字段（16）的长度显示为显示第二行个I之后的前两位数字。注：此字段不能用手持式编程器更改。但是，它可以使用Logicmaster 90-30/20/Micro软件组态器功能进行更改。手持式编程器将始终反映状态字段的当前有效长度。11 11-26 Series 90-30 PLC I/O模块规格–2000年7月GFK-0898F按下ENT键将允许PLC选择状态数据的起始地址。您可以通过按所需地址的键序列并按ENT键来选择特定的起始地址。例如，为了将起始地址指定为I17， Initial Display R0:03 EMPTY >S To add the IC693ALG392 module to the configuration, press the READ/VERIFY, ENT key sequence. The following screen will be displayed: R0:03 AO 1.00 >S I16:I_ Selecting %I Reference At this point the starting %I reference address for the status data returned from the module must be entered. Notice that the length of the status field (16) is displayed as the first two digits following the first I on the second line of the display. Note This field cannot be changed with the Hand-Held programmer. However, it can be changed using the Logicmaster 90-30/20/Micro software configurator function. The Hand-Held Programmer will always reflect the currently active length of the status field. 11 11-26 Series 90-30 PLC I/O Module Specifications – July 2000 GFK-0898F Pressing the ENT key will allow the PLC to select the starting address of the status data. You can select a specific starting address by pressing the key sequence for the desired address and pressing the ENT key. For example to specify the starting address as I17,
