P3EDb HENF452778R1伺服驱动使用书工控卡件PLC/DCS备件模块

手持式编程器。但是，它可以使用Logicmaster 90-30/20/Micro软件组态器功能进行更改。手持式编程器将始终反映状态字段的当前有效长度。您可以随时按下CLR键中止刚才选择的配置，并将插槽返回为空。11模拟输出模块GFK-0898F1章–模拟输出模块11-27从配置中移除模块如果需要，可以从当前机架配置中移除此模块。假设模块当前配置在机架0插槽3中。可以按以下顺序删除：初始显示R0:03 AO 1.00>S AQ8:AQ_要删除模块，请按DEL，ENT键顺序。然后显示为：R0:03 EMPTY>S如果在DEL键（而不是ENT键）之后按下了CLR键，则删除操作将被中止。选择模块默认模式模块的默认停止模式，HOLD（保持）或DEFLOW（除霜），可根据需要使用以下程序进行显示和修改。the Hand-Held programmer. However, it can be changed using the Logicmaster 90-30/20/Micro software configurator function. The Hand-Held Programmer will always reflect the currently active length of the status field. You can press the CLR key at any time to abort the configuration you have just selected and return the slot to EMPTY. 11 Analog Output Modules GFK-0898F Chapter 11 – Analog Output Modules 11-27 Removing Module From Configuration If required, this module can be removed from the current rack configuration. Assume that the module is currently configured in rack 0, slot 3. It can be deleted with the following sequence: Initial Display R0:03 AO 1.00 >S AQ8:AQ_ To delete the module, press the DEL, ENT key sequence. The display will then be: R0:03 EMPTY >S If the CLR key had been pressed after the DEL key (instead of the ENT key), the delete operation would have been aborted. Selecting Module Default Mode The default STOP mode of the module, either HOLD or DEFLOW, can be displayed and modified, if required, by using the following procedure.