模块从运行模式切换到停止模式。当该值设置为保持（默认）时，输出将保持其后状态。当您将此值更改为DEFLOW时，输出将变为零。其他配置注意事项%I大小中的条目只接受8、16和24，并且只接受%I地址。此字段表示返回给用户的位数。%AI Ref Adr的允许条目是%AI地址。同样，%AQ Ref Adr的允许条目是%AQ地址。每个通道的报警下限必须小于其相应的报警上限。%AI Ref Adr字段是%AI数据的参考地址，指向%AI内存中输入数据开始的位置的开始。每个通道提供16位模拟输出数据，作为0到32767或–32768到32767的整数值。取决于所选择的范围类型。%AQ Ref Adr字段是%AQ数据的参考地址，指向%AQ内存中输出数据到模块的起始位置。
the module is toggled from RUN to STOP mode. When this value is set to HOLD (default), the outputs will retain their last state. When you change this value to DEFLOW, the output will go to zero. Other Configuration Considerations The entry in %I Size will only accept 8, 16 and 24, and will accept only %I addresses. This field denotes the number of bits returned to the user. The only allowable entries for the %AI Ref Adr are %AI addresses. Similarly, the only allowable entries for the %AQ Ref Adr are %AQ addresses. The Alarm Low limit for each channel must be less than its corresponding Alarm High limit. The %AI Ref Adr field is the reference address for the %AI data and points to the start of the locations in the %AI memory where the input data to the module begins. Each channel provides 16 bits of analog output data as an integer value from 0 to 32,767 or –32768 to 32,767. depending on the range type selected. The %AQ Ref Adr field is the reference address for the %AQ data and points to the start of the locations in the %AQ memory where the output data to the module begins.
