使用↑ 和↓ 箭头光标键或#键显示所选插槽。初始显示R0:03 EMPTY=Y=N如果不想保存对CPU的更改，请按CLR键。将显示以下信息：DISCARD CHGS=Y=N如果不想放弃所做的更改，请按CLR键。这将使您返回到上次修改的参数，所有更改都保持不变。如果您确实想放弃所做的更改，请按ENT键。然后，手持式编程器将返回上次修改的参数，并将数据重置为先前值。如果要从保存更改中将数据保存到CPU？如上图所示，按下ENT键。如果模块处于冻结模式，手持式编程器将在屏幕上返回CFG ERR消息，如下所示：R0:03*CFG ERR 30m VersaMax:所有电源、I/O和通信模块绝缘绝缘耐受UL508、UL840、IEC664 1.5KV，适用于额定电压为51v至250v的模块，电源输入Dips，变体EN 61000-4-11*运行期间：Dips至30%和100%，AC 10%的变化、DC 20%的变化*EN 61000-4-x系列测试在技术上等同于IEC 1000-4-x和IEC 801-x系列。注1：模块特定批准Use the ↑ and ↓ arrow cursor keys or the # key to display the selected slot. Initial Display R0:03 EMPTY =Y =N If you do not want to save changes to the CPU, press the CLR key. The following message will be displayed: DISCARD CHGS? =Y =N If you do not want to discard the changes you have made, press the CLR key. This will return you to the last parameter that was being modified with all changes intact. If you do want to discard the changes you have made, press the ENT key. The Hand-Held Programmer will then return you to the last parameter that was being modified with the data reset to its previous value. If you want to save the data to the CPU from the SAVE CHANGES? screen shown above, press the ENT key. If the module is in freeze mode, the Hand-Held Programmer will return with a CFG ERR message on the screen as follows: R0:03*CFG ERR 30m VersaMax: All power supply, I/O, and communication modules ISOLATION Dielectric Withstand UL508, UL840, IEC664 1.5KV for modules rated from 51v to 250v POWER SUPPLY Input Dips, Variations EN 61000-4-11* During Operation: Dips to 30% and 100%, Variation for AC 10%, Variation for DC 20% * EN 61000-4-x series of tests are technically equivalent to the IEC 1000-4-x and IEC 801-x series. Note 1: Module specific approvals are
